T40P DSS Deal Type?

[GIWM]

I am setting up some T40P units and in my provisioning template set:

transfer.dsskey_deal_type = 0

However, the T40P units don't seem to take this setting. Firmware is 54.81.0.60. I can change it in the web interface and it works just fine.

Any idea what I may be doing wrong?

[CWR]

transfer.dsskey_deal_type = 0 worked fine on my T48G.
Have you exported your config file just to check that Yealink didn't have a spelling issue in the programming... never know.

[GIWM]

(03-28-2017 08:33 PM)craigreilly Wrote:  transfer.dsskey_deal_type = 0 worked fine on my T48G.
Have you exported your config file just to check that Yealink didn't have a spelling issue in the programming... never know.

It worked fine on my T46G as well. Just not the T40P.

When I did the export settings on the T40P, there's no dss anywhere to be found. In fact, there are only two transfer. settings.

Perhaps I need to make a feature request? Though nothing indicates it SHOULDN'T work.

[jolouis]

Sounds like a bug, especially if it works properly from the web interface without issue. Unfortunately I don't have a T40 here to test and confirm but it's probably worth submitting a request to Yealink support to have them check it.

[Travis_Yealink]

It's confirmed to be a bug, and we release a new firmware to fix this issue: 54.81.0.76
http://ftp.yealink.com/?ShareToken=74E1F...84C275ADE7

Regards,
Travis_Yealink

[GIWM]

(04-26-2017 02:08 AM)Travis Wrote:  It's confirmed to be a bug, and we release a new firmware to fix this issue: 54.81.0.76
http://ftp.yealink.com/?ShareToken=74E1F...84C275ADE7

Regards,
Travis_Yealink

That firmware does indeed fix the bug. Thank you for getting this fixed for us!