How To Disable Ring Back Tone in Yealink W52P

[rizvirgo]

Hello Team,

Will you please guide me how to disable ring back tone in yealink w52p?
I have selected the region Australia.
But when I select Custom it gives fields to edit but do not know what to write in that fields.
Guide me
Thanks in advance.

[rizvirgo]

Hello Team,

Anyone can reply to the above post,
Thank you

[complex1]

Hi,

I have found this for you:

Customizes the dial tone.
tonelist = element[,element] [,element]…
Where

element = [!]Freq1[+Freq2][+Freq3][+Freq4] /Duration

Freq: the frequency of the tone (ranges from 200 to 7000 Hz).

If it is set to 0Hz, it means the tone is not played. A tone is comprised of at most four different frequencies.

Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.

You can configure at most eight different tones for one condition, and separate them by commas. (e.g., 250/200, 0/1000, 200+300/500, 600+700+800+1000/2000).

If you want the IP phone to play tones once, add an exclamation mark “!” before tones (e.g., !250/200, 0/1000, 200+300/500, 600+700+800+1000/2000).

Hope it help.

[rizvirgo]

(04-10-2015 02:14 AM)complex1 Wrote:  Hi,

I have found this for you:

Customizes the dial tone.
tonelist = element[,element] [,element]…
Where

element = [!]Freq1[+Freq2][+Freq3][+Freq4] /Duration

Freq: the frequency of the tone (ranges from 200 to 7000 Hz).

If it is set to 0Hz, it means the tone is not played. A tone is comprised of at most four different frequencies.

Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.

You can configure at most eight different tones for one condition, and separate them by commas. (e.g., 250/200, 0/1000, 200+300/500, 600+700+800+1000/2000).

If you want the IP phone to play tones once, add an exclamation mark “!” before tones (e.g., !250/200, 0/1000, 200+300/500, 600+700+800+1000/2000).

Hope it help.

Hello Team,

I am looking for this
thank you