[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Phone termination issues
Author Message
nikko Offline
Junior Member
**

Posts: 1
Joined: Apr 2013
Reputation: 0
Post: #1
Phone termination issues
Hello,
I am not sure if support answers forums faster than emails so i will try both. I am considering upgrading some older polycom phones in the call center to Yealink phones on the advise of a vendor. I ordered one T38 to test but after recieving and setting it up in a PIAF environment, the phone has some termination issues. Here is what it does.
when i make an outbound call, the terminating phone will ring quickly and hang up and show a missed call, then it will ring again, all the while the originating t38 shows as ringing with one call. I have not seen anything in the logs to indicate this is two calls and cannot understand what causes this behaviour. this is a default set up with only the acct name and pw added. all other default settings were left alone. this behaviour is non existent in all the polycom phones that have a basic default setup as well. I have sent a pcap via email to support if that helps.

thanks
04-08-2013 10:53 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Yealink Support Offline
Administrator
*******

Posts: 2,683
Joined: Dec 2012
Reputation: 25
Post: #2
RE: Phone termination issues
Hello Mark,
I already replied to you in the support Ticket, so could you help to check our questions and confirm to us ASAP?
Thanks.
04-09-2013 03:29 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 


Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  How to reset to a 'normal' phone oliverjl 5 4,989 02-11-2023 06:29 PM
Last Post: complex1
  Phone will only ring through headset leecramman 4 11,992 09-01-2021 12:49 AM
Last Post: leecramman
  POE failure causing phone to reboot jasit 1 10,990 11-09-2017 07:32 AM
Last Post: Aishion_Yealink
  Phone Panel not dialing out - no errors Cleartrunk 2 11,115 08-15-2015 11:52 AM
Last Post: Cleartrunk
  Phone not working with 802.1x md5 validation. fabianochoueiri@yahoo.com.br 2 10,989 07-25-2015 05:30 AM
Last Post: fabianochoueiri@yahoo.com.br
  Customizing phone user interface mdu113 2 11,413 07-24-2015 05:48 AM
Last Post: mdu113
  T38G issues Jadzia 3 12,088 05-18-2015 06:11 AM
Last Post: rafael@protel.inf.br
  T38G transfer failed to an other phone or PSTN Digicel AFG 3 13,556 12-04-2014 04:35 AM
Last Post: Digicel AFG
  T32G phone died Grumblegeek 1 9,027 05-04-2014 11:21 PM
Last Post: Yealink Support
  38.70.0.168 (Supported by 3CX Phone System) jasit 11 35,064 12-09-2013 11:32 AM
Last Post: Yealink Support

Forum Jump:


User(s) browsing this thread:

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication