New screen capture feature on T26P

[jcaruso]

I am trying to use the new screen capture feature of the 6.73.0.40 firmware on a T26P. I have gone into Features > Remote Control and added my computers IP address to Action URI allow IP List. How do I actually capture the screen though? Is it a custom URL I visit for the phone?

[Yealink_Daniel]

Hi,

Please follow these steps to capture the current screen of the phone:
1. Enter request URI (e.g., http://10.3.20.8/screencapture) in the browser's address bar and press the Enter key on the keyboard.
2. Do one of the following:
- If it is the first time you capture the phone’s current screen using the computer, the browser will display “remote control forbidden”, and the LCD screen will prompt the message “Allow Remote Control?”.
   
Press OK soft key on the phone to allow remote control. The phone will return to the previous screen.
Refresh the web page.
The browser will display an image showing the phone’s current screen. You can save the image to your local system.
- Else, the browser will display an image showing the phone’s current screen directly. You can save the image to your local system.

Note: Frequent capture may affect the phone performance. Yealink recommend you to capture the phone screen display within a minimum interval of 4 seconds.

If there is any questions, please do not hesitate to contact me.

Thank you.

Best Regards
Daniel