[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Excessively loud side-tone in some calls
Author Message
brady Offline
Junior Member
**

Posts: 2
Joined: Nov 2014
Reputation: 0
Post: #1
Question Excessively loud side-tone in some calls
Hi All,
We set up a dozen t28p's in our office a few months ago and have noticed that some calls have very loud side-tone (almost the same volume as we said it).

I have played around with the settings but cannot seem to pinpoint what is causing this..

The issue is a little better with the volume turned down on the handset and when on speakerphone.
We have also checked recordings on the PBX itself and the calls are crystal clear, no echo is present.

Does anyone have any ideas on what we should be looking at?
Is there any way to disable sidetone on these phones?
11-10-2014 01:20 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Wilson_Yealink Offline
Administrator
*******

Posts: 171
Joined: Aug 2014
Reputation: 0
Post: #2
RE: Excessively loud side-tone in some calls
Hi brady,

Please try below steps:
1. Access to web gui->Settings->Voice tab, set value of ECHO to enabled.

2. We have a feature named Side Tone(side tone is the feature that you speak then you can hear your own voice less than 12ms), this feature can be disabled via below autop command:
Code:
#!version:1.0.0.1
#Configure the volume of the side tone. It ranges from -48 to 0, the default value is -3.
voice.side_tone=

For more information, please refer to the auto guide.
Auto_Provisioning_Guide_V72_30

thanks
11-10-2014 04:33 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
brady Offline
Junior Member
**

Posts: 2
Joined: Nov 2014
Reputation: 0
Post: #3
RE: Excessively loud side-tone in some calls
Thanks for the quick reply.
Echo is already enabled, I will try pushing out voice.side_tone option to my test phone tomorrow.
I did not see it in the provisioning guide, what does the value range represent?

I did find an older manual that says it can be turned off completely with a different value?
http://www.poisetechnology.com/newsPDF/A...01.2.2.pdf
"It is an invisible setting which can only be
configured via auto provision.
-32768 stands for Disable Side tone.
-3 stands for Enable Side tone.
The default is -3"
11-10-2014 04:45 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 


Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  W78P wont receive calls dleather 1 814 12-22-2022 12:15 AM
Last Post: dleather
  MP56 with EXP50 Side Car Problems rockey@autechllc.com 0 753 12-02-2022 09:28 PM
Last Post: rockey@autechllc.com
  From field user part incomplete on some outbound calls oliv 1 1,023 11-25-2022 06:14 PM
Last Post: oliv
  W80 Emergency Calls with Locked Keypad sandro84 0 2,020 10-18-2021 07:57 PM
Last Post: sandro84
  Silencing / Rejecting Queue Calls asafayan 1 3,551 07-13-2021 03:45 AM
Last Post: complex1
  RTCP-XR MOS-CQ scores 0 on many calls CyVon 0 2,602 04-01-2021 04:18 AM
Last Post: CyVon
  Making calls without registration : T22P phatcow 3 10,941 02-09-2021 09:59 PM
Last Post: naveenhome64
  Calls to more than three participants? It's possible? Cimmerio 4 6,767 01-29-2021 10:13 PM
Last Post: Yisroel_MongoTEL
  Is there a way to stop incoming calls from being muted Janelle 0 2,957 11-16-2020 07:05 AM
Last Post: Janelle
  Low intercom tone volume haukzinn 0 3,090 07-18-2020 08:27 PM
Last Post: haukzinn

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication