YEalink T28p v 2.72.0.30

[fabster]

Good afternoon,
I'm trying to perform semi-attended call tranfer and attended the call drops and blind tranfer only if it works
Help..
sorry for my english.

[fabster]

hello there ,, her we go again i have Zultys MX250 v 7.2.4 and still now working the attended-tranfer.

[Yealink Support]

Hi fabster,

How about the steps now?
Does the semi-attended transfer work well now?
If it still doesn't work well now, could you describe the detailed operations ?
You can also refer to the guide firstly. >>guide<<
Begin page at 116.

thanks

[fabster]

HI there, thnks for yout help.
this case still not working:
those are the steps:
1. make or recive a call
2. the tranfer: a. i press tran key and the numeber or ext i will like to tranfer an press # or ok key to execute and wait until call is attended

b. i press tranfer softkey and put the number o ext and i wait until the call its attended

3 when my call is attended i press tran key to send my step 1.

when i do this the call always is drop ( step 1)

Only blind tranfer is working

[Yealink_Jim]

Hi,
I suggest that you can upgrade to the V73 beta version and reset the phone to the default factory setting to chekc if it can solve this issue.
Pay attention to that reset to factory setting will clear all configuration.

Please go to below link to get the V73 beta version:

http://forum.yealink.com/forum/announcements.php?aid=8

Hope this helps!

[fabster]

thnks i will try and let you know Jim .

[fabster]

(10-23-2014 04:43 PM)Yealink_Jim Wrote:  Hi,
I suggest that you can upgrade to the V73 beta version and reset the phone to the default factory setting to chekc if it can solve this issue.
Pay attention to that reset to factory setting will clear all configuration.

Please go to below link to get the V73 beta version:

http://forum.yealink.com/forum/announcements.php?aid=8

Hope this helps!

Hello again,
i try and is not working
Versión
Versión Firmware 2.73.0.16
Versión hardware 1.0.0.53
Redes
Puerto de internet IPv4
i follow the same steps and its not workin the attended tranfer only blind tranfer works.
I dont know if is something about audio codec´s be cuz my PBX Zultys MX250 handle many codecs like g729.

any more sugestions will be great.

[Yealink_Jim]

Hi,
You can set up as below picture (to diabled the Local Anonymous) :



If it still can't work, would you please give me the Correct Syslog, Config.bin and Trace files?
About hao to get the Correct Syslog, Config.bin and Trace files, you can refet to below FAQ:

http://forum.yealink.com/forum/showthread.php?tid=1319.


Hope this helps!