[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020


Post Reply 
 
Thread Rating:
  • 1 Votes - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
W52P Connectivity problems "out of range" or "synchronizing"
Author Message
gadget Offline
Junior Member
**

Posts: 3
Joined: Jun 2016
Reputation: 0
Post: #1
Tongue W52P Connectivity problems "out of range" or "synchronizing"
We have a total of 4 bases with 4 handsets. Only 2 bases are within range of each other. We get "out of range" and "synchronizing failed" randomly. Oddly enough, if we are on a phone call, it will never drop. Only when the phone is in standby mode will this issue occur. You cannot make a call, or receive a call when the issue occurs. It could be 30secs or 10min and it will just start working. All the phones do it and always have done it since install 6-8 months ago. Walkie talkies are more reliable than these phones, unfortunately. There is no schedule, and the other bases have the same issue, but all are completely random. One base and handset may have the issue, and the other 3 will be working fine. I cannot nail this one down.. Any help would be awesome. I am running 25.73.0.40 firmware.
(This post was last modified: 06-24-2016 02:45 AM by gadget.)
06-24-2016 02:43 AM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Olivia1982 Offline
Junior Member
**

Posts: 1
Joined: Jun 2016
Reputation: 0
Post: #2
RE: W52P Connectivity problems "out of range" or "synchronizing"
Hey!
I have the same problem. I looked through the forums and found nothing. I'm sunning on the same firmware. It started with one phone only, now two of them aren't working. Any ideas?

Olivia
06-27-2016 04:13 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
dlginformatica Offline
Junior Member
**

Posts: 1
Joined: May 2016
Reputation: 0
Post: #3
RE: W52P Connectivity problems "out of range" or "synchronizing"
we have the same problem. we have 5 handset registered to the 4 based, we have set the bestbase e not set eco and eco+, but the handset not change the base even if the signal is hight, then we force register and the handset is ok.

someone you can help us?
thank's
07-14-2016 03:38 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
JSM Communications Offline
Junior Member
**

Posts: 15
Joined: Jan 2015
Reputation: 0
Post: #4
RE: W52P Connectivity problems "out of range" or "synchronizing"
We also have 1 client with this problem!

We have loads of clients that use the W52 and dont have this problem.
Only this client has this problem ...

Firmware: 25.73.0.40

Factory reset does not fix the problem...
If anyone knows a solution, we are happy to hear it.

Thanks in advance,
Nathan.
07-18-2016 08:53 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Sylvain Offline
Junior Member
**

Posts: 2
Joined: Jan 2017
Reputation: 0
Post: #5
RE: W52P Connectivity problems "out of range" or "synchronizing"
I have the same problem using firmware 25.73.202.6 for the Base and 26.73.202.21 for the Handset.
Does anyone resolved this issue yet about Connectivity problems "out of range" or "synchronizing" » ?
12-10-2018 08:17 PM
Find all posts by this user    like0    dislike0 Quote this message in a reply
complex1 Offline
3CX Adv. Cert. Engineer
*****

Posts: 1,509
Joined: Jan 2014
Reputation: 43
Post: #6
RE: W52P Connectivity problems "out of range" or "synchronizing"
(12-10-2018 08:17 PM)Sylvain Wrote:  I have the same problem using firmware 25.73.202.6 for the Base and 26.73.202.21 for the Handset.
Does anyone resolved this issue yet about Connectivity problems "out of range" or "synchronizing" » ?

Hi,

Please update the firmware of base and handset to the newest one, then reset base to factory default and test again.

Firmware download link or contact your provider:
http://support.yealink.com/documentFront...umentId=25

At the same time, have you enable the ECO mode of the base? If yes, please disable it and test again!

Hope this will help.

Kind regards,
Frank.

I am not an employee of Yealink.
Dutch is my native language, not English. Apologies for my imperfect grammar.
Please do not send unsolicited PM messages. I will not answer them.
12-11-2018 08:40 AM
Find all posts by this user    like0    dislike0 Quote this message in a reply
Post Reply 


Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  T58 Call Park and Transfer Problems user42491 1 5,435 08-03-2021 09:24 PM
Last Post: complex1
  [SOLVED] T41S and T41P problems with backlight jeroentjed 11 25,556 02-06-2021 06:21 PM
Last Post: complex1
  [W52P+W56P] Same base station with with different handset models - Auto-provisioning Asanka 5 18,882 08-25-2017 02:21 PM
Last Post: SteveDavies
  cannot disable auto provisioning W52P - W56H Babaloo71 5 16,009 02-21-2017 06:59 AM
Last Post: Karl_Yealink
Bug [W52P] SIP CANCEL with "Call completed elsewhere" shows missed call x0r 7 30,919 12-08-2016 08:00 AM
Last Post: smiso
  W52P headset capabilities jgreer 2 12,426 06-24-2016 02:25 AM
Last Post: gadget
  W52P Crashing (memory leak?) damo@launtel.net.au 7 20,204 05-31-2016 10:39 AM
Last Post: damo@launtel.net.au
  New W52P won't go into discover mode jxv110 1 8,757 05-20-2016 03:59 AM
Last Post: Hermsen
  W52P - outgoing call no sound msth 5 19,550 05-04-2016 01:09 AM
Last Post: Babaloo71
  W52P Firmware minooch 3 12,773 04-30-2016 09:50 PM
Last Post: Karl_Yealink

Forum Jump:


User(s) browsing this thread:

Contact Us   Yealink   Return to Top   Return to Content   Lite (Archive) Mode   RSS Syndication