No attended transfer with BLF key after firmware update

[telepathinc]

Cached Browsers really create havoc when programming phones as you had to press F5

Change browsers, change computers, do something different.

And yes by the way "it is the penultimate parameter."

[Flora_Yealink]

(12-18-2012 09:13 PM)Werner Wrote:  Hi Flora,

yes, you are right !

I did not find this param because it was not correctly displayed on my pc, until I pressed F5 in my browser to reload the page.
I guess the reason is that I formerly had administered the same phones with the old Firmware installed, which does not have that param.

Thanks

Werner

Hi Werner,
Yes, the broswer cache sometimes result in this problem, happy to hear it is OK now.
Best Regards!

[troosters]

I changed the provisioning template (3CX) from

#Enable or disable the transfer DSS key to perform the blind transfer; 0-Disabled, 1-Enabled (default);
features.dsskey_blind_tran =

to

#Enable or disable the transfer DSS key to perform the blind transfer; 0-Disabled, 1-Enabled (default);
features.dsskey_blind_tran = 0

But in my T28 it is still on blind transfer.
Why would it not take it ??

[Lucas1]

Hi ,troosters

This is yealink technical support, nice to contact you.
Could you please tell us which firmware do you use firstly?

[troosters]

(10-25-2014 12:11 PM)Yealink_Lucas Wrote:  Hi ,troosters

This is yealink technical support, nice to contact you.
Could you please tell us which firmware do you use firstly?

Hi i am using 3cx v12 sp 6.1 and yealink 2.71.0.225 firmware

[Lucas1]

Hi, troosters

Thank you for your info,
I am afraid that T2X in this version don't support this config(features.dsskey_blind_tran).
So if you want to achieve this feature, please try the config as below.

#Define the way of DSS key when configuring as a transfer key; 0-Display Number, 1-Attended Transfer, 2-Blind Transfer (default);
transfer.dsskey_deal_type =

[sebdar]

I'm on the T22P with the latest firmware 7.73.0.50 and when transfering: TRAN - ext. num. - TRAN (either hard key or soft key) is being transferred as a blind call even though the "Transfer Mode Via Dsskey" is set to "Attended Transfer"

All the other settings in Features - Transfer are set to disable.
Any idea how can I disable blind transfer.
I'm on T22P and T26P phones combined with Elastix 2.5