T46G - - Intercom - Call Barge Issue

[Yealink Support]

Hi Abe, do you enable answer-after=0 in your PBX?

[paypwip]

Having the Same issue with a 3CX server. The phone and Config File both say that this is disabled.

[Yealink Support]

Do you enable this feature in PBX?

[mortsmel]

I continue to have this issue and need it resolved.

[davemcbr]

I am having the same issue. When on an active call and someone intercoms an extension it will put the first call on hold and auto answer the incoming call. Using T46g on firmware
T46-28.80.0.95

using :

Call-info:answer-after=0

Intercom barge : Disable

Using Mangovoice

Works great with all other manufacturers


i also have Alert-Info: <alert-internal> for internal ringing set. I dont know if that makes any difference

[davemcbr]

(01-22-2014 11:39 PM)Abe1048 Wrote:  Hi Support!

When a T46G user is on the line, and someone pages or intercoms them, it puts the first call on hold automatically, and then after the page they can resume the first call (barge in).

This happens even though call barge is disabled on the phone.

I would appreciate if someone could be at help

I have this same issue once i upgraded to 36.80.0.60 on all T4 series phones. I sent pcap and Syslog level files to yealink and have still not had any response. I also sent a email directly to support@yealink.com any am wating to hear something.
Interestingly enough this was the version when they enabled for dual outbound proxy servers. Which we use. I dont know if there is a correlation.