redial adding SIP URI failure

[mikejohnstone]

We have a combination of T46G and T19 and T41P.

A consistent issue against the T48G when redialling missed calls redialling is adding the SIP URI (@103.55.11x.x) to the phone number eg 0289606500@103.55.11x.x.

This behaviour is unique to the T46 and none of the other office phones. I have compared the phone settings and cant see any meaningful differences with the other Yealink models. The only difference is firmware between the various models.

We are using the defaults on setup.

Firmware 28.80.0.70.

[Karl_Yealink]

Hi,

Suggest that you can reset the phone can test again.
If possible, you can register the account to other phones for a test.

[mikejohnstone]

Hi Karl
We are an ITSP - VoIP service provider. The bebhavior described is limited just to the T46g. I have tried factory resetting, applying different numbers and even changing to alternate platforms. Any further suggestions....

[Karl_Yealink]

Hi,

You can try the syntax below via auto provisioning and test again.
features.redial_via_local_sip_server.enable = 1