T46G Call Fwd DSS Key enables / disables ALL fwd types

[Aishion_Yealink]

(02-06-2018 03:46 AM)MintTelecom Wrote:  

(02-06-2018 03:30 AM)Aishion_Yealink Wrote:  Dear customer,

I just test on my side with latest firmware:28.82.0.20, and found that this firmware works normally, and you will only have Always forward options when you configure through this way, example as below:

You set a forward key and set a value as a forward number, then you save the configure, once you press the key, the phone will automatically enable/disabled Always forward, you don't need to choose which type you want to configure.

So would you please kindly try to download below latest firmware and test again?

http://download.support.yealink.com/down...2.0.30.rom

Any question, please feel free to contact us.

Best Regards

Aishion

Hi Aishion,

Can you please confirm which lines you're populating in the config and with what values?

When you enable a forward key, it does enable and disable the Always Forward setting, but it also enables and disables the Busy and No Answer settings, which I don't want to change - I want them to remain on always.

Dear customer,

Yes, I check on my Web UI and only Always forward enabled, may I know which firmware are your phone running? Or you can kindly upgrade to the latest firmware and test again.

Any question, please feel free to contact us.

Best Regards

Aishion