CP860 Recovery Mode Stuck at Start Updating

[YMCS/YDMP Free Trial Program]Yealink would like to offer Free Trial Program of Yealink device management service for our current eligible customers. You can see the details below.
https://www.yealink.com/ydmp-freetrial-2020

Thread Rating:

0 Votes - 0 Average
1
2
3
4
5

Threaded Mode \| Linear Mode CP860 Recovery Mode Stuck at Start Updating
Author	Message

sentinelace Offline

Junior Member

Posts: 8

Joined: Aug 2016

Reputation: 1

Post: #1

CP860 Recovery Mode Stuck at Start Updating

I cannot login to this phone so I am trying to use the recovery firmware which I have. I point to my TFTP server and it just says "start updating" and never moves. It's not my tftp server because I did a recovery on my T41's no issue same way. I ready somewhere I can do recovery with USB. How is this done? There is no USB option when you boot holding the soft key.

12-19-2018 02:24 PM

« Next Oldest | Next Newest »

Messages In This Thread

CP860 Recovery Mode Stuck at Start Updating - sentinelace - 12-19-2018 02:24 PM

Possibly Related Threads...
Thread:		Author	Replies:	Views:	Last Post
	CP860 does not work connected to PC	msc	9	34,098	02-12-2022 06:22 AM Last Post: robertrenninger
	CP860 EoL?	njackson	1	10,120	07-10-2018 04:38 PM Last Post: johnkiniston
	How do you reboot CP860 without unplugging?	bitblock	1	9,912	03-30-2018 08:54 PM Last Post: bitblock
	How do I connect CP860 to monitor system?	Breogg	1	10,748	03-19-2018 03:18 PM Last Post: Aishion_Yealink
	Compatibility CP860 with other SIP Server	albani	1	10,023	12-04-2017 03:14 PM Last Post: jolouis
	Compatibility CP860 with other SIP Server	albani	0	7,233	12-04-2017 02:04 AM Last Post: albani
	Compatibility CP860 with other SIP Server	albani	0	6,916	12-04-2017 02:00 AM Last Post: albani
	CP860 change sensitivity of Microphones	universe.noc	9	36,047	08-14-2017 02:45 AM Last Post: Sas
	Release notes for CP860-37.80.0.30	HaraldL	2	13,986	06-09-2017 03:26 PM Last Post: HaraldL
	CP860 doesn't boot	engine411	8	28,273	02-09-2017 04:39 PM Last Post: engine411

Forum Jump:

User(s) browsing this thread:

Log in