Using a Trunk for OUTBOUND calls only - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Configuration (/forumdisplay.php?fid=24) +--- Thread: Using a Trunk for OUTBOUND calls only (/showthread.php?tid=988) |
Using a Trunk for OUTBOUND calls only - TotallyVoip - 11-04-2013 07:16 PM T28P - Firmware Version 2.70.23.10 Is there a way of configuring the phone to be able to use an Account for outbound calls only? Preferably without maintaining permanent registration to the server, so it only connects when a call is dialed ? The Bria softphone (PC/Android/iPhone) and Android's own built in Voip setup allow this (Allow incoming calls = no), but I can't seem to see any way of doing this on the Yealink ? Any pointers appreciated Thanks, Richard RE: Using a Trunk for OUTBOUND calls only - Yealink Support - 11-13-2013 04:25 PM Hi TotallyVoip, Our DECT phone has this feature and can assign the handset just can do outgoing calls. "Preferably without maintaining permanent registration to the server, so it only connects when a call is dialed." Just to use the ECO+ mode can perfectly meet your need. if you want to add this feature to T28, you should contact with your distributor. They will help to push your request. RE: Using a Trunk for OUTBOUND calls only - TotallyVoip - 11-16-2013 12:14 AM (11-13-2013 04:25 PM)Yealink Support Wrote: Hi TotallyVoip, Thanks, it's a shame there is no way of doing this. For inbound calls, is there any way of showing during the ringing phase, the actual identity/trunk that the call is coming in on? RE: Using a Trunk for OUTBOUND calls only - Yealink Support - 11-20-2013 05:29 PM Hi TotallyVoip, Do you mean when a call coming in, the LCD of phone can display the caller location? Why do you want to use this feature? |