Yealink Forums
t46g Can't enable VPN and Upload VPN Config Tar - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: T4x Series (/forumdisplay.php?fid=31)
+--- Thread: t46g Can't enable VPN and Upload VPN Config Tar (/showthread.php?tid=982)



t46g Can't enable VPN and Upload VPN Config Tar - grooveion - 11-02-2013 06:44 AM

T46g with firmware version 28.71.0.170 - trying to enable vpn and upload a tar with the vpn file and certs.

I go to network advanced, then under VPN I change the Active select box to Enabled.

I click the "Browser" button, browse to the openvpn.tar (which is on e:\openvpn.tar) and after I select the file from my E: drive, I click OK.

The uneditable textbox labeled "Upload VPN Config" reads "c:\fakepath\openvpn.tar".

I click upload and I get a success dialog with an OK button

I click OK and the browser refreshes the page.

The Active select is back to disabled, the path is blank and the confirm button responds that I should upload a file first.

Please help.


RE: t46g Can't enable VPN and Upload VPN Config Tar - Yealink Support - 11-02-2013 09:35 AM

Hi grooveion,

Please make sure you name cnf as "vpn.cnf" in default, and re-pack as tar file.
Please try again.