TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Wishlist (/forumdisplay.php?fid=13) +--- Thread: TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND (/showthread.php?tid=957) |
TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - acrz6666 - 10-26-2013 07:34 PM Hello. Why is it not possible to reduce the time out for dial-now rule to 0 seconds? I do not see the benefit of waiting one second, the minimum. Regards. RE: TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - braymond - 12-05-2013 09:25 AM I feel the same way. The phone should have the ability to dial as soon as a Dial-now rule is found. Especially when the "Using Dial Plan Feature on Yealink SIP-T2XP Phones" guide says this (on page 3): NOTE: 1) By default, the delay time for Dial-now would be 1 second 2) Configurable time would be 0~14seconds Thanks, Benoit RE: TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - deutschnaftyula - 01-03-2014 09:35 AM I have a 0 and its working fine, just put 0 RE: TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - ivanp - 06-10-2014 09:31 AM (01-03-2014 09:35 AM)deutschnaftyula Wrote: I have a 0 and its working fine, just put 0 Neither T42 nor T46 allow setting value 0 for the dial-now time out. Both are on the latest firmware available: V72 (29.72.0.25 and 28.72.0.25) RE: TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - CWR - 06-10-2014 12:27 PM 0 seconds is not good. I can't dial a 7 digit local call hat is near match to an internal extension. Ie Internal extension 4954 Local number 495-4000 If I have wait set to 0 - then I always get 4954 and not 495-4000. RE: TIME OUT FOR DIAL-NOW: MINIMUM = 1 SECOND - tsukraw - 10-13-2014 11:56 AM Just wanted to update this post. In version 73 beta 2 release notes. It states "Fixed the issue that Time Out for Dial-now Rule cannot be set to “0”. I have tested it and zero does indeed work on the T46 and T48 now |