Multicast paging worked but no longer works - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Configuration (/forumdisplay.php?fid=24) +--- Thread: Multicast paging worked but no longer works (/showthread.php?tid=740) |
Multicast paging worked but no longer works - plewis@bcradesign.com - 08-13-2013 12:42 AM We have a lot of t28p phones with firmware 2.70.0.103, using 3cx. We use Snoms for our paging, but in a couple of areas, we were using T28 with the new multicast paging feature, which was working, but it suddenly stopped, and we cannot get it working again on any T28. Paging still works as always on the SNOMs, so we know our networking is fine, and switch settings have not changed. The interesting thing is, the phone receives the multicast signal, and displays properly, and the phone double beeps and then clicks like it wants to receive the audio, but nothing comes out of the speaker. Can you suggest something for me to try? Thanks, phil just noticed one difference between my snoms (where paging works) and t28 (paging doesn't work) and that's that the snom LAN address is static on 192.168.75.x:2048, and the yealink phones are DHCP and are using ports 5062, 5063, 5064, etc. could this be a factor? RE: Multicast paging worked but no longer works - CWR - 08-13-2013 03:20 AM check the audio codec in use as the static ip vs dhcp ip should not matter. multicast is using a different address range - right? ie: 239.0.0.1:50001 Code: ####################################################################################### RE: Multicast paging worked but no longer works - plewis@bcradesign.com - 08-13-2013 03:27 AM [quote='craigreilly' pid='2860' dateline='1376335234'] check the audio codec in use as the static ip vs dhcp ip should not matter. multicast is using a different address range - right? ie: 239.0.0.1:50001 [code] ####################################################################################### ## Multicast ## ####################################################################################### #Configure the codec of multicast paging. multicast.codec = PCMU correct where can I paste the text here - since most / all of the config files seem to be xml, not txt files. ####################################################################################### ## Multicast ## ####################################################################################### #Configure the codec of multicast paging. multicast.codec = PCMU the common cfg files seem all to be in use - what has to happen to edit those, stop phone system? RE: Multicast paging worked but no longer works - CWR - 08-13-2013 07:37 AM Not sure what system you are on - so I can not help you... I just know the Config files from Yealink are CFG files - which contain plain text. |