Trigger Call? - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: T4x Series (/forumdisplay.php?fid=31) +--- Thread: Trigger Call? (/showthread.php?tid=637) |
RE: Trigger Call? - dapster105 - 10-29-2013 05:11 PM Thank you - click to dial now works perfectly! There is one small issue with this new firmware. Every few seconds the phone screen flashes up with a big Yealink logo which is quite distracting. Is that because this is a beta firmware or is there some new setting that I need to switch off? I'm holding off rolling out this firmware because I know I'm going to get complaints about it from the users - it flashes up for about 2 seconds every 10 seconds which is quite irritating. A second question is, where can these updated firmwares normally be found? I couldn't find this version on the Yealink site anywhere. Thanks for your help with this! (10-29-2013 05:11 PM)dapster105 Wrote: There is one small issue with this new firmware. Every few seconds the phone screen flashes up with a big Yealink logo which is quite distracting. Is that because this is a beta firmware or is there some new setting that I need to switch off? Ok - found it way down the bottom of the Features->General Information section. "Use logo" now Off. RE: Trigger Call? - Yealink Support - 10-29-2013 05:27 PM Hi dapster105, 1. You can turn off the logo in the webpage->Features->General Information->Use Logo, turn it off.(attachment) 2. You can find the latest version in the Support module of yealink site. I make a screenshot for all of you. RE: Trigger Call? - luppas - 05-16-2014 04:34 AM Hi Guys Has the remote dialing command for the T48 changed form the T46? Is it still http://username:password@IPADDRESS/servlet?number=PHONENUMBER&outgoing_uri=SIPUSER@SIPSERVER Or does the T48 have a new command for remote dial? Thanks RE: Trigger Call? - Yealink Support - 05-16-2014 09:25 AM Hi luppas, Can you use the same command in T46G and work well? I think the correct command should be: http://username:password@IPADDRESS/servlet?key=number=PHONENUMBER&outgoing_uri=SIPUSER@SIPSERVER |