+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Auto Provisioning (/forumdisplay.php?fid=14)
+--- Thread: Customize DSS key via Configuration File (/showthread.php?tid=617)
Customize DSS key via Configuration File - allen@millermanor.net - 07-10-2013 08:44 AM
I am using Yealink T22 phones with 3CX. What I would like to do is edit the 3CX configuration file that creates the MAC.cfg files to add a customized DSS key to each phone. I see that the section and lines I want are:
[ memory13 ]
DKtype = 16
Line = 0
type = blf
Value = SP0
This corresponds to in 3CX lingo a Shared Park 0 key.
I have made edits to yealink.ph.xml to modify other settings like changing the Time Format to 12 hour mode. However, I can't figure out how to get the DSS key to work. I feel there is just something I don't understand because adding these lines to the mac.cfg file do not get the desired result.
I hope I have explained this clearly and appreciate your assistance.
Regards,
Allen Miller
RE: Customize DSS key via Configuration File - Yealink Support - 07-10-2013 10:34 AM
Hi Allen,
I will forward your issue to our USA special team support.usa@yealink.com, there your issue will have higher priority.
Thanks.
RE: Customize DSS key via Configuration File - allen@millermanor.net - 07-10-2013 11:00 AM
Thank you.
Allen
RE: Customize DSS key via Configuration File - FSchulz - 08-07-2013 09:41 PM
Could u please make a post here, how to solv that problem? thank you
RE: Customize DSS key via Configuration File - scramatte - 10-07-2013 07:23 AM
I don't know how to provision DSS key on T20P and T26P with firmware 7.1 ?
Can you post an example how t achieve this per phone ?
RE: Customize DSS key via Configuration File - Kaly01 - 10-29-2013 10:56 PM
Yeah, nice post you'll made here. And also the nice and quite appreciable reply by the admin. Nice going.
RE: Customize DSS key via Configuration File - CWR - 10-29-2013 11:18 PM
Allen - you do not mention what firmware you are using or what version of 3cx. Normally I use this in the 3cx Template File. Then when you make an edit to the extension, it recreates the cfg file for the handset assigned to that extension (based on Mac address).
memorykey.1.line = 1
memorykey.1.value = SP1
memorykey.1.type = 10
memorykey.1.xml_phonebook =
But because it is for a T22 without the extra 10 buttons (T38, T28, T26) then you need to use a line key which should be like this:
linekey.1.line = 0
linekey.1.value = SP1
#linekey.1.pickup_value =
linekey.1.type = 10
linekey.1.xml_phonebook =
linekey.1.label = SP1
scramatte - T20 and T26 will each be different if you intend to use the buttons on the side of the T26.
Firmware for the above code should be this or higher:
The T26 should be using: 6.70.0.168 for 3CX
The T22 should be using: 7.70.0.168