+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: T4x Series (/forumdisplay.php?fid=31)
+--- Thread: T48G - Dial From History Issue - Firmware 35.80.0.70 (/showthread.php?tid=5653)
T48G - Dial From History Issue - Firmware 35.80.0.70 - CTCJM - 09-09-2015 03:47 AM
Scenario:
Call comes to Ring Group A.
Call is missed.
Caller is dialed via touch screen call history logs.
Call is shown as DialedNumber@PBX.Public.IP.Address@PBX.DomainName.com
A standard call should show DialedNumber@PBX.DomainName.com
This causes bad resolution in dialed number and name.
All other methods of dialing work properly.
It only happens with this firmware version 35.80.0.70.
Any ideas would be appreciated.
RE: T48G - Dial From History Issue - Firmware 35.80.0.70 - James_Yealink - 09-09-2015 04:44 AM
Hello,
You can configure this parameter through autoprovision and check again.
features.redial_via_local_sip_server.enable = 1
If you don't set up a provision server in your side.
Please go to web interface-> Setting-> Configuration, import follow CFG file to phone.
ftp://James:494qh65Z@ftp.yealink.com/autop/redial_via_local_sip_server.cfg
Regards,
James