Yealink Forums
Replace Rule in Dial Plan fails for URI Addresses - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Phone specific topic (/forumdisplay.php?fid=12)
+---- Forum: T2xP Series (/forumdisplay.php?fid=21)
+---- Thread: Replace Rule in Dial Plan fails for URI Addresses (/showthread.php?tid=488)

Replace Rule in Dial Plan fails for URI Addresses - ruiseixas - 05-26-2013 06:58 AM

Hi,

Why if you place the follwing Replace Rule in the Dial Plan, the phone gives bad r-uri?

Code:
Index: 1
Number: 7001
Replace: name@sip.com
Account: 2

But this one, with "name" instead "name@sip.com" calls without problems!

Code:
Index: 1
Number: 7001
Replace: name
Account: 2

Regards,
Rui

RE: Replace Rule in Dial Plan fails for URI Addresses - Yealink Support - 05-27-2013 11:19 AM

Hello,
Do you mean when you fill attached setting in the phone webpage, the phone will prompt bad r-uri?
But I tied it and works well?
Could you upgrade to our latest firmware and try again?(What's the model you used?)
If you use T2X phones, please upgrade to the firmware x.70.0.140:
http://www.yealink.com/SupportDownloadfiles_detail.aspx?CateId=184&flag=142
And reset to factory default.
Thanks.

RE: Replace Rule in Dial Plan fails for URI Addresses - ruiseixas - 05-27-2013 09:52 PM

(05-27-2013 11:19 AM)Yealink Support Wrote:  Hello,
Do you mean when you fill attached setting in the phone webpage, the phone will prompt bad r-uri?
But I tied it and works well?
Could you upgrade to our latest firmware and try again?(What's the model you used?)
If you use T2X phones, please upgrade to the firmware x.70.0.140:
http://www.yealink.com/SupportDownloadfiles_detail.aspx?CateId=184&flag=142
And reset to factory default.
Thanks.

Hi,

No, I mean in the phone, when you try to make the call (7001#), the phone gives that error in their LCD!

Regards,
Rui

RE: Replace Rule in Dial Plan fails for URI Addresses - Yealink Support - 06-04-2013 04:55 PM

Hi Rui,
I tried it here, dial 7001, and it can dial out name@sip.com normally.
So please check whether you have the latest firmware, i use x.70.0.140 firmware.
Thanks.