+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: T4x Series (/forumdisplay.php?fid=31)
+--- Thread: Hotdesking how to make key after username (password) use numbers by default (/showthread.php?tid=47335)
Hotdesking how to make key after username (password) use numbers by default - fergusinc - 02-10-2024 04:21 AM
By default the person can use the keypad and it will automatically use numbers EG Ext 1234
Then they hit the down arrow and the:
Password
Prompt shows up but this time the row below the display has these:
Cancel | abc | Delete | Save
All our passwords are numbers, so the Hot Desker must hit the abc key a few times to get to the 123 part.
Is there someway to program it so this key always starts with 123 and not abc?
Thanks!
RE: Hotdesking how to make key after username (password) use numbers by default - complex1 - 02-10-2024 06:38 PM
(02-10-2024 04:21 AM)fergusinc Wrote: By default the person can use the keypad and it will automatically use numbers EG Ext 1234
Then they hit the down arrow and the:
Password
Prompt shows up but this time the row below the display has these:
Cancel | abc | Delete | Save
All our passwords are numbers, so the Hot Desker must hit the abc key a few times to get to the 123 part.
Is there someway to program it so this key always starts with 123 and not abc?
Thanks!
Hi,
I think this is by design, but you should actually ask the Yealink helpdesk.
https://ticket.yealink.com/