+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: Dect Phone Series (/forumdisplay.php?fid=6)
+--- Forum: W60B（Wireless） (/forumdisplay.php?fid=59)
+--- Thread: W70B and WH62 headset - headset again pairing with default base after in cradle (/showthread.php?tid=46360)
W70B and WH62 headset - headset again pairing with default base after in cradle - Philipp Biermann - 01-04-2023 01:44 AM
Using the WH62 Headset together with the W70B is a good Idea.
After updating the FW of the headset I was able to pair with a W70Base.
However, when I return the HS to the base for charging purposes, the HS pairs again automatically with the base which was delivered with the HS.
To use the headset after charging I have again to pair it with W70B.
This behaviour makes not much sense.
How can I disable the automatic re-paring?
RE: W70B and WH62 headset - headset again pairing with default base after in cradle - markvdheijden - 01-05-2023 07:06 PM
(01-04-2023 01:44 AM)someone Wrote: Using the WH62 Headset together with the W70B is a good Idea.
After updating the FW of the headset I was able to pair with a W70Base.
However, when I return the HS to the base for charging purposes, the HS pairs again automatically with the base which was delivered with the HS.
To use the headset after charging I have again to pair it with W70B.
This behaviour makes not much sense.
How can I disable the automatic re-paring?
I guess you did not change the headset base mode correctly. please use the steps below:
Switching Method: Hold the Voice button and Phone button of the
headset base for 5 seconds. The PC, Voice and Phone button LED indicator
on the headset base will flash four times.
LED Indicator Status: When you successfully switch to Multi-Cell mode,
only the Voice button on the base grows white
Regards,
Mark
RE: W70B and WH62 headset - headset again pairing with default base after in cradle - Yisroel_MongoTEL - 01-06-2023 12:48 AM
Here's the PDF from Yealink with the instruction (on page 6):
[attachment=6319]