Yealink Forums
disable provisioning on T26P - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Auto Provisioning (/forumdisplay.php?fid=14)
+--- Thread: disable provisioning on T26P (/showthread.php?tid=44917)



disable provisioning on T26P - yeaphild - 02-25-2021 07:25 PM

I recently bought a used T26P, and reset to factory defaults.
The firmware version is 6.73.0.50. I am going to use it with FreePBX.

Whenever I power it on, after 2 minutes of initializing, a message appears
"Sending Provision Requests"...for another minute, then "update skipped!".

?? I have set up 3 other Yealink phones ( all with Freepbx ) and none of them
show this message. They also power up in just over a minute ( vs 2 ).

I checked the settings in the phone, but because I am a bit new to SIP
phones, I'm not sure where to look ( tried auto-provision under settings...)

Can anyone help me disable this message? I don't use auto-provisioning,
and I'd certainly like this phone to initialize more quickly!

Thanks,