How to configure T27G TRAN key in Call Fwd Custom mode ? - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Configuration (/forumdisplay.php?fid=24) +--- Thread: How to configure T27G TRAN key in Call Fwd Custom mode ? (/showthread.php?tid=43938) |
How to configure T27G TRAN key in Call Fwd Custom mode ? - oliv - 04-07-2020 02:20 PM Hello, T27G phones have a TRAN key which is very convenient to use when Call Fwd mode is Phone and a single account is set. How do you configure it in Call Fwd Custom mode ? I've tried with: features.fwd.allow = 1 features.fwd_mode = 1 forward.idle_access_always_fwd.enable = 1 account.1.always_fwd.target = 1 account.1.always_fwd.on_code = *60*9134* account.1.always_fwd.off_code = *61*9134 programmablekey.14.type = 2 programmablekey.14.line = 1 When TRAN key is pressed, I would expect it to show an Always Forward menu with the following content: Always fwd: Enable Forward target: 1 On code: *60*9134* Off code: *61*9134 With the above config, when TRAN key is pressed an Always Forward menu appears, which is fine but its content is empty as with: Always fwd: Enable Forward target: On code: Off code: Then, if I edit this menu with valid Fwd target, on and off code, no On or Off code is sent over the network through my configured SIP account. How can I debug this ? In other words, how do you configure one phone Key to gather forwarding input for one SIP account, and an other phone Key to gather input for another SIP account ? Best regards |