Yealink Forums
Action URI in W52P - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: Dect Phone Series (/forumdisplay.php?fid=6)
+--- Forum: W52P (Wireless) (/forumdisplay.php?fid=23)
+--- Thread: Action URI in W52P (/showthread.php?tid=43242)



Action URI in W52P - RRC_Support - 10-03-2019 08:48 PM

Hi Team!
Is there any possibility in W52P of external control of equipment via http requests - like this is implemented in T21 and others.

In the web interface there is no way to configure allowed addresses. Via provisioning cfg too..


RE: Action URI in W52P - anonymous1711612242218 - 10-22-2019 01:27 PM

(10-03-2019 08:48 PM)RRC_Support Wrote:  Hi Team!
Is there any possibility in W52P of external control of equipment via http requests - like this is implemented in T21 and others.

In the web interface there is no way to configure allowed addresses. Via provisioning cfg too..

Dear Customer

Good day. This is Garry from Yealink Technical Support Team. Nice to know you.

Our W52P does not support "remote control". You can configure the phone only through the W52H UI, or through the Base web side or by using Auto provision.

If you want to log into the W52P web side, you need to register W52H to Base first. Then you can press the "Paging" button on Base to display the IP address on W52H or check the IP address on the registration handle and then use the IP address to go to the Base page and configure the phone.

If you need an Auto provision configuration, you can follow T21's Auto provision deployment.

In the attachment, I have sent you the user guide and administrator guide of W52P. Meanwhile, you can enter the official website of W52P for more information through the link below.
http://support.yealink.com/documentFront/forwardToDocumentDetailPage?documentId=25

Any upgrade, please let me know.

Best Regards
Garry