Auto provision firmware ... - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Auto Provisioning (/forumdisplay.php?fid=14) +--- Thread: Auto provision firmware ... (/showthread.php?tid=42717) |
Auto provision firmware ... - Yuriy Y. - 04-25-2019 11:45 AM Hello! I use auto provisioning * .boot MAC.boot ... include:config <main.cfg> ... main.cfg ... [T19 E2] static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom [T21P E2] static.firmware.url = tftp://10.1.0.5/ya/fw/52.84.0.15.rom [T23G, T23P] static.firmware.url = tftp://10.1.0.5/ya/fw/44.84.0.15.rom [T29G] static.firmware.url = tftp://10.1.0.5/ya/fw/46.83.0.50.rom [T40G, T40P] static.firmware.url = tftp://10.1.0.5/ya/fw/54.84.0.15.rom [T41P] static.firmware.url = tftp://10.1.0.5/ya/fw/36.84.0.15.rom [T41S, T42S, T46S, T48S] static.firmware.url = tftp://10.1.0.5/ya/fw/66.84.0.15.rom [CP960] static.firmware.url = tftp://10.1.0.5/ya/fw/73.83.0.30.rom ... T19 phones do not want to be updated! If you ask a command static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom everything is fine T19 phone gets an update. Ok. But I have a lot of different phones of different models. I share the update paths by model. I call the parameter [$model]. from 53.81.14.1 > to 53.84.0.15 [T19 E2] static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom [T19_E2] static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom [T19P E2] static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom [T19P_E2] static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom In this case, the phone does not want to be updated !!! Similar problems with T21 phones! T40, T41, T29 - updated normally! Why? It is a bug? Thanks! RE: Auto provision firmware ... - Yuriy Y. - 04-26-2019 05:40 AM What happened to find out! [T19P_E2] static.firmware.url = tftp://10.1.0.5/ya/fw/53.84.0.15.rom The line is not accepted! This line only works with version 83 ...! Thank you, I solved the problem, changed the logic ... |