![]() |
Auto provisioning seams to be (partly) broken in version 83 for T46G - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Auto Provisioning (/forumdisplay.php?fid=14) +--- Thread: Auto provisioning seams to be (partly) broken in version 83 for T46G (/showthread.php?tid=41946) |
Auto provisioning seams to be (partly) broken in version 83 for T46G - HaraldL - 07-06-2018 10:49 AM Since Upgrading to T46-28.83.0.35 the provisioning doesn't work reliable on the T46G. But still the same configuration works for T48G phones. for example BLF pickup_value ** doesn't work or at least only works sometimes. The value simply doesn't get written in the phone config. It works if I set this value manually in the webinterface. We distribute the following config files to the phones: boot config: Code: #!version:1.0.0.1 default config: Code: #!version:1.0.0.1 mac config: Code: #!version:1.0.0.1 It works sometimes and sometimes it doesn't. Downgrading to Version 82 seams to work. RE: Auto provisioning seams to be (partly) broken in version 83 for T46G - HaraldL - 07-16-2018 07:01 AM no answer is a bad answer? I downgrade all phones and they are working again... RE: Auto provisioning seams to be (partly) broken in version 83 for T46G - Fraukas2 - 07-02-2019 03:04 PM Hello, I know this is an old post, but I think the firmware version 84 also has this problem. On my T46S with firmware 66.84.0.15, when I factory reset my phone, it gets re-provisionned by the RPS. Then it gets configured with all my BLFs from my auto provision server. For testing purposes, if I manually place 2-3 BLFs to N/A instead of BLF, and trigger the auto-provision or if I restart the phone, the BLFs doesn't get configured. I thought maybe the problem was that username or password in the auto-provision was too complex, but placing them back to 1234567890 for both didn't make the phone provision correctly. |