T46 hardware versions and multicast paging - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: T4x Series (/forumdisplay.php?fid=31) +--- Thread: T46 hardware versions and multicast paging (/showthread.php?tid=4128) |
T46 hardware versions and multicast paging - ComResource - 07-18-2015 01:29 AM Hello, We are testing 2 different T46 phones. One is hardware version 28.1.0.128.0.0.0 with firmware 28.73.0.48 (most recent as of this post). The other phone is hardware version 28.2.0.128.0.0.0 with the same firmware. I have the following lines in my provisioning template for multicast paging: multicast.receive_priority.enable = 1 multicast.receive_priority.priority = 0 multicast.listen_address.1.label = Page All multicast.listen_address.1.ip_address = 224.0.0.30:10000 When provisioning both phones with this template, the phone with hardware version 28.1.0.128.0.0.0 applies the paging settings successfully. The other phone (hw version 28.2.0.128.0.0.0) will not apply any settings. It is very, very strange. The ONLY difference between these two phones is the hardware version. I know I could set it manually, but I shouldn't have to. Anyone have any ideas? RE: T46 hardware versions and multicast paging - James_Yealink - 07-18-2015 05:14 AM Hello, Can you please reset phone and check again. Regards, James RE: T46 hardware versions and multicast paging - ComResource - 08-19-2015 03:53 AM (07-18-2015 05:14 AM)Yealink_James Wrote: Hello, Hi James, I have factory reset the phones and rebooted the phones numerous times. It does not help the issue. Thank you RE: T46 hardware versions and multicast paging - ComResource - 12-15-2015 03:09 AM Bump. RE: T46 hardware versions and multicast paging - CWR - 12-15-2015 03:27 AM I recommend trying another address. perhaps 239.0.0.1:10001 (you never know with these things... always some strange behavior) |