Yealink Forums
T48s show Talking on users who are not on an active call - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: T4x Series (/forumdisplay.php?fid=31)
+--- Thread: T48s show Talking on users who are not on an active call (/showthread.php?tid=41051)

Pages: 1 2 3 4


RE: T48s show Talking on users who are not on an active call - Daodeth - 11-03-2017 02:28 PM

(11-03-2017 02:21 PM)Scott311 Wrote:  
(11-03-2017 02:17 PM)Daodeth Wrote:  These 2 phones are doing showing talking, one is a t48s the other is T42s. What bothers me is that the T46s are all fine.

That doesn't look like the entire config of the phone. Mine was about 100-120 lines.

Yeah I just saw that at the to heading where not all password settings are not shown. Trying to figure out how to get the whole CFG.


RE: T48s show Talking on users who are not on an active call - stratos - 05-24-2018 12:17 PM

(11-03-2017 02:28 PM)Daodeth Wrote:  
(11-03-2017 02:21 PM)Scott311 Wrote:  
(11-03-2017 02:17 PM)Daodeth Wrote:  These 2 phones are doing showing talking, one is a t48s the other is T42s. What bothers me is that the T46s are all fine.

That doesn't look like the entire config of the phone. Mine was about 100-120 lines.

Yeah I just saw that at the to heading where not all password settings are not shown. Trying to figure out how to get the whole CFG.

Any solution to this yet? We are having the same issue.

Thanks.


RE: T48s show Talking on users who are not on an active call - Scott311 - 05-24-2018 12:32 PM

(05-24-2018 12:17 PM)stratos Wrote:  
(11-03-2017 02:28 PM)Daodeth Wrote:  
(11-03-2017 02:21 PM)Scott311 Wrote:  
(11-03-2017 02:17 PM)Daodeth Wrote:  These 2 phones are doing showing talking, one is a t48s the other is T42s. What bothers me is that the T46s are all fine.

That doesn't look like the entire config of the phone. Mine was about 100-120 lines.

Yeah I just saw that at the to heading where not all password settings are not shown. Trying to figure out how to get the whole CFG.

Any solution to this yet? We are having the same issue.

Thanks.

This parameters needs to be set, I did not find it ANYWHERE on the phone, I simply had to add it to the config. Depending on your VOIP provider you may be able to add it to a global paramaters list.

transfer.hang_up_after_success_trans=1