T4X no beep on intercom answer - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: T4x Series (/forumdisplay.php?fid=31) +--- Thread: T4X no beep on intercom answer (/showthread.php?tid=40717) |
T4X no beep on intercom answer - jcaruso - 03-22-2017 07:50 PM We are utilizing two way intercom feature on one of our tenants. When they intercom from a T26 it will beep on the dialing phone once it connects to the other phone. When they intercom from a T48 or a T41 there is no beep or tone when the phones connect. The settings under Features > Intercom match on both the T26 and T48. I've also tested on a T41P and it does not beep as well. Is there a way to enable the beep once the intercom is answered on the T4X? The settings on Features > Intercom are set as follows: Allow Intercom - Enabled Intercom Mute - Disabled Intercom Tone - Enabled Intercom Barge - Disabled RE: T4X no beep on intercom answer - Lucia_Yealink - 03-23-2017 09:38 AM HI, Can you tell me what is the version of the firmware? Please kindly provide the level 6 syslog, config.bin and pace trace when you reproduce the issue to do further analyze. You can refer to the FAQ below to get the three files: http://support.yealink.com/faq/faqInfo?id=313 Before you do a test, please update the firmware to the latest version, go to the website to download the firmware: http://support.yealink.com/documentFront/forwardToDocumentFrontDisplayPage How many phones you have in total? and how many of them have the issue? RE: T4X no beep on intercom answer - JohnJ - 04-12-2022 04:46 AM // SECURITY OPTION 1 // BEEP AN AUDIO ALERT WHEN AN INTERCOM STARTS features.intercom.tone="1" // SECURITY OPTION 2 // MUTE YOUR MIC – WHEN AN INTERCOM STARTS features.intercom.mute="1" // INTERCOM CONVERSATIONS RING YOUR PHONE TO ANSWER INSTEAD. // LIFTING THE HANDSET(0) VS HANDSFREE CONVERSATION (1). features.intercom.allow="1" // BLOCK INTERCOM CALLS DURING ACTIVE CALLS // It enables or disables the phone to answer an incoming intercom call while there is already an active call on the IP phone. features.intercom.barge="0" |