Autonegotiate on PC port broken in new firmware - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: T4x Series (/forumdisplay.php?fid=31) +--- Thread: Autonegotiate on PC port broken in new firmware (/showthread.php?tid=40534) |
Autonegotiate on PC port broken in new firmware - dig1234 - 01-16-2017 09:48 PM Since version 36.80.0.95 connecting a Wyse thin client into PC port on T41P creates a duplex mismatch port goes up and down every 5 seconds.. Reverting to 36.80.0.70 solves the issue. I've tried 36.80.0.130 with same issue. Also if I hard set the port to 100 Full it works fine. The Wyse is set to Auto. Tried different hardware same results. RE: Autonegotiate on PC port broken in new firmware - dig1234 - 01-17-2017 09:00 PM Just test latest version. 36.81.0.25 suffers from same issue. RE: Autonegotiate on PC port broken in new firmware - Quinlan_Yealink - 02-04-2017 07:40 AM Dear Sir Could you help load syslog to us analysis? you can refer to following link: http://support.yealink.com/faq/faqInfo?id=313 RE: Autonegotiate on PC port broken in new firmware - MikeMWLC - 07-24-2017 01:15 PM (02-04-2017 07:40 AM)quinlan Wrote: Dear Sir Hello, I have taken over this issue from my colleague and I've attached the requested log files. Can you please advise? The auto-negotiate will work for a few seconds and then drop again. Only setting the phone manually to full duplex will resolve the issue which is not a plausible solution. Thank you, Mike |