T20 initializing please wait - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Phone specific topic (/forumdisplay.php?fid=12) +---- Forum: T2xP Series (/forumdisplay.php?fid=21) +---- Thread: T20 initializing please wait (/showthread.php?tid=3894) |
T20 initializing please wait - ORANUX - 06-01-2015 09:52 PM Dear suddenly our T20 phone stop booting and display this message on screen ( initializing please wait), we try recovery mode via TFTP but after finishing update, same problem. is there any procedure can help to solve this issue. Regards, RE: T20 initializing please wait - James_Yealink - 06-02-2015 12:28 AM Hi, We have replied you in ticket. Regards, James RE: T20 initializing please wait - fmanhica1 - 06-03-2015 04:33 PM HI all, hi have the same problem with 2 sip-t20p phones, i have try recovery mode via tftp but after finishing update, problem persists. initializing please wait any solution for this? best regards HI all, hi have the same problem with 2 sip-t20p phones, i have try recovery mode via tftp but after finishing update, problem persists. initializing please wait any solution for this? best regards (06-02-2015 12:28 AM)Yealink_James Wrote: Hi, RE: T20 initializing please wait - James_Yealink - 06-04-2015 03:39 AM In TFTP server, can you see a firmware download record? Please make sure that phone download firmware correctly. If phone still not work, there is no other way to restore. Does the issue occur after a faliure firmware upgrading or a sudden power outage? Regards, James RE: T20 initializing please wait - ORANUX - 06-04-2015 09:53 PM Hi for our case, suddenly phone stop working without any modification on firmware.. attached snapshot for TFTP Updating RE: T20 initializing please wait - James_Yealink - 06-04-2015 10:59 PM So it doesn't work after recovery mode update? If yes, please rename it to T20.rom and check again. It's case-sensitive. Also you can try another T20 firmware. Regards, James RE: T20 initializing please wait - fmanhica1 - 06-07-2015 07:53 PM (06-04-2015 10:59 PM)Yealink_James Wrote: So it doesn't work after recovery mode update? hi, its happen after a power failure, i have tried to upgrade with 2 diferent version and its loaded sucessfull but after restart it stops on the same point. " initializing please wait " |