+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: Dect Phone Series (/forumdisplay.php?fid=6)
+--- Forum: W52P (Wireless) (/forumdisplay.php?fid=23)
+--- Thread: The network status LED doesn't light (/showthread.php?tid=3664)
The network status LED doesn't light - terin - 04-18-2015 04:09 AM
Hi,
on my Yalink W52P, network status LED doesn't light, only the power light is turned.
After the reset all 3 lights works but the dhcp server does not detect the device.
Do you have any ideas how to fix this problem?
RE: The network status LED doesn't light - Flora_Yealink - 04-18-2015 06:11 AM
Hi ，
Would you please reboot the BASE again to see what happen ?
after reboot, please check whether these three lights still on .Normally when the second light is on , it means the phone have obtained the correct IP address and you mentioned that the third light handset light is on as well which means at least one handset has connected to the BASE. In this case , would you please check what is the IP address of the BASE and whether it can work normally?
Best Regards!
RE: The network status LED doesn't light - terin - 04-21-2015 08:49 PM
I tried this procedure several times and it doesn’t work.
There is just the first light (the power), the others do not light.
RE: The network status LED doesn't light - Flora_Yealink - 04-22-2015 03:38 PM
In this scenario , it seems the base doesn't obtain the network and there is no handset registered to the base.
you mentioned " just the power light turns on but other lights are off " ,may i know after you do the factory default ,what is the status of the network indicator ? if the network indicator won’t light up solidly but flashes continually, it means that the W52P can’t get an IP address ,in this case, would you please try to check if you can register the handset to the base and configure the static IP address for it ? and make sure the network cable can work well .
If it still can't work it maybe the hardware issue, please contact your vendor or local distributor and send the problem description for help.
If you can't get a support from them, please send an email which include problem description, test result, your country, phone SN number to Support@yealink.com
If only power light turn on , but the network ligth is off , maybe hardware issue.
and during the hard reset process, did all the three lights trun on one by one or only the power light turn on durning the whole process? only one power light turn on during the whole process, maybe the hardware issue .