Yealink Forums
Remote dail T46 ( ) - Printable Version

+- Yealink Forums (
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Configuration (/forumdisplay.php?fid=24)
+--- Thread: Remote dail T46 ( ) (/showthread.php?tid=35690)

Remote dail T46 ( ) - dennisboutrup - 11-04-2016 08:59 PM

I am trying to figure out how to remote dail on a T46.

I followed this one:
And as far as i could google i need to set:
ActionURIShowMsgBox = 0

I downloaded the config.bin, changed it from notepad++, let the phone reboot and checked the config.bin again to test that its still in the config.

To avoid the lcd pop up (i dont have access to the phone - only on remote and i need to place a test call to do some debugging on the firewall).

Is there any other way to advoid the on screen verification?

I can see the screencapture does'nt come up until the next firmware

RE: Remote dail T46 ( ) - jolouis - 11-08-2016 02:18 PM


is the provisioning entry you need. I believe it is only effective on more modern firmware (I know it doesn't work on .72 firmware on T2X phones, not sure about T46. It does work on version .80 and above). Description of this entry is in the admin guide for the newer firmware.