+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: T4x Series (/forumdisplay.php?fid=31)
+--- Thread: T48G UC-Feature not working (/showthread.php?tid=3345)
T48G UC-Feature not working - flatman - 02-24-2015 01:41 AM
Hello all. Thanks in advance for helping.
I'm an engineer testing these Yealink T48G phones, and everything is working great. however, I'm trying to enable the UC feature using the following parameters
features.uc.enable = 1
features.uc_username = xxxxx
features.uc_password = xxxxx
phone_setting.dsskey_directory_auto.enable = 0
features.config_dsskey_length =
Now normally ...after I save the configuration file and then reboot the phone, I log into the Gui-interface and EXPORT the configs to make sure that the phone actually took the configs..----Now when I export the configs...the only configurations for UC I see is the following:
features.uc_username = xxxxx ( can't show my username)...
It doesnt seem like the "Features.uc.enable =1" is even being accepted by the phone...
I would be greatly appreciated if someone could assist... I called support but they're away for the Chinese holiday until the 26th of Feb, 2015..
I'm using a T48G phone with the Broadsoft Solution firmware ( 35.73.193.40 )
RE: T48G UC-Feature not working - jmac - 02-24-2015 03:10 AM
I think you want features.uc_enable instead of features.uc.enable
RE: T48G UC-Feature not working - flatman - 02-24-2015 03:34 AM
(02-24-2015 03:10 AM)jmac Wrote: I think you want features.uc_enable instead of features.uc.enable
Thanks for the reply.
However I tried and and it still didn't work.
(02-24-2015 03:34 AM)flatman123 Wrote:(02-24-2015 03:10 AM)jmac Wrote: I think you want features.uc_enable instead of features.uc.enable
Thanks for the reply.
However I tried and and it still didn't work.
When i export the configurations.. theses are the only uc-parameters being recieved by the phone:
features.uc_username = Yealink.T48G@xxxxx
How is it possible that the phone see the username parameter but not the rest of the uc-configuration parameters?