+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Phone specific topic (/forumdisplay.php?fid=12)
+---- Forum: T2xP Series (/forumdisplay.php?fid=21)
+---- Thread: T-19 Dial Plan does not work (/showthread.php?tid=3324)
T-19 Dial Plan does not work - joes - 02-17-2015 06:54 AM
i am working in peer to peer mode and tried to configure the phone to automatically dial the IP number of the person i'm looking for by using the replace function for example
prefix - 500
dial 192.168.21.100
when trying to dial 500 i'm receiving the message unknown URI scheme BUT if i am dialing directly the IP number everything is working.
can i use the dial plan in peer mode?
RE: T-19 Dial Plan does not work - James_Yealink - 02-17-2015 05:37 PM
Hi Joes,
Dial Plan in Yealink phones can't be used to replace an IP address.
Regards,
James
RE: T-19 Dial Plan does not work - telepathinc - 05-01-2015 05:25 AM
we dial IP all the time
dial 192*168*1*103
In fact our phones dial ALL EXTENSIONS using 4xx
Phones are static IP to 192.168.1.EXT
dial plan is 4(xx) replaced with 192*168*1*1$1
this assumes extensions 1xx and replace your IP scheme as needed
RE: T-19 Dial Plan does not work - Danila - 04-25-2017 07:22 PM
T20P E2
Firmware 52.81.0.70
The same problem
Prefix:
1([0-9])([0-9])
Replace:
172.16.10.1$1$2
Replace works fine, but outgoing call goes through sip-account
Dialed List:
Mon Apr 24 20:52 xxxxx@ip.b24-7183-1437148721.bitrixphone.com 172.16.10.101 172.16.10.101@ip.b24-7183-1437148721.bitrixphone.com
What should I do not to use a sip account when making a call?