+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Phone specific topic (/forumdisplay.php?fid=12)
+---- Forum: T2xP Series (/forumdisplay.php?fid=21)
+---- Thread: Auto provision T20p firmware 9.70.23.6 (/showthread.php?tid=3222)
Auto provision T20p firmware 9.70.23.6 - premier - 01-29-2015 10:39 PM
Guys,
i don't know if this has been asked before, if yes my apologies for repeating, but is there a way to auto provision T20p with 9.70.23.6 firmware version?
or to make it more general, from which firmware version and above is auto provisioning available?
RE: Auto provision T20p firmware 9.70.23.6 - James_Yealink - 01-30-2015 08:51 AM
Hi,
T20P with 9.70.23.6 support autoprovision.
May I know what you want configure through autoprovision? Some parameter supported in latest firmware may not be supported in V70.
Regards,
James
RE: Auto provision T20p firmware 9.70.23.6 - premier - 02-02-2015 04:32 PM
(01-30-2015 08:51 AM)Yealink_James Wrote: Hi,
T20P with 9.70.23.6 support autoprovision.
May I know what you want configure through autoprovision? Some parameter supported in latest firmware may not be supported in V70.
Regards,
James
Hi James,
how can i arrange for 9.70.23.6 to be autoprovisioned? i can even find it in the phone interface, can you please send me instructions /print screen etc?
all i want is to arrange for the firmware to be auto upgraded.
RE: Auto provision T20p firmware 9.70.23.6 - James_Yealink - 02-03-2015 01:45 PM
Hi,
Can you check whether the attached instruction make sense.
It describes how to do an autoprovision.
For upgrading firmware, you have to put the rom file into http server firstly then write the upgrading parmaeter in the cfg file like:
firmware.url = http://<server address>/9.73.0.40.rom
Regards,
James
RE: Auto provision T20p firmware 9.70.23.6 - premier - 02-05-2015 04:39 PM
Hi James,
thanks for the info but the problem is that i don't have the autoprovision option on older firmware versions.
from a certain version and above, where i have this option, i managed to do it. the problem is that i don't know how to auto upgrade older version phones.
(02-03-2015 01:45 PM)Yealink_James Wrote: Hi,
Can you check whether the attached instruction make sense.
It describes how to do an autoprovision.
For upgrading firmware, you have to put the rom file into http server firstly then write the upgrading parmaeter in the cfg file like:
firmware.url = http://<server address>/9.73.0.40.rom
Regards,
James