Yealink Forums
T28P Multicast Paging Volume - Printable Version

+- Yealink Forums (
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Configuration (/forumdisplay.php?fid=24)
+--- Thread: T28P Multicast Paging Volume (/showthread.php?tid=2520)

T28P Multicast Paging Volume - fdtcloud - 10-08-2014 01:44 AM

We have many installations of Yealink T28P phones using Multicast paging. Several customers are requesting a way to lower the volume of the Mulicast page. Other than adjusting the volume while the page is active is there a setting to change in the auto provisioning file to lower this volume globally?

RE: T28P Multicast Paging Volume - Wilson_Yealink - 10-09-2014 08:14 PM

Hi fdtcloud,

There are two methods to adjust the volume of the multicast paging:
1. Via phone user interface:
When you are in paging call, you can press the volume up/down key directly to adjust the volume.
2. Via auto provision to adjust the volume, the autop sentence are below:

##It configures the receiving volume of handset. The default value is 8.Integer from1 to 15.
voice.handset.spk_vol =
##It configures the receiving volume of speaker. The default value is 8. Integer from1 to 15
voice.handfree.spk_vol =

You can get the autop guide and template from below link:
Yealink T2XP AutoProvisioning Template (X.72.0.30)
Yealink SIP-T2XP phones Auto Provision User Guide_V72