+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Phone specific topic (/forumdisplay.php?fid=12)
+---- Forum: T2xP Series (/forumdisplay.php?fid=21)
+---- Thread: Message light or flash not working (/showthread.php?tid=2506)
Message light or flash not working - joelbenroth - 10-01-2014 10:55 PM
I have a T26 set up with Ring Central. I have configured MWI according to the Admin manual. However, the message light does not light up and there is no flashing when there is a voice mail message.
I have attached a screen shot of the Account>Advanced settings, the Features>Power LED settings, and the Status showing firmware, etc.
Please help!
RE: Message light or flash not working - Lucas1 - 10-17-2014 05:23 PM
Hi joelbenroth,
This is a yealink technical support, Lucas, nice to cintact you.
I see your attachment,it seem to be no problem and I test my side,it is also OK. so could you please reset the factory firstly?
And note: MWI service is not available on all servers. Contact your system administrator for more information.
Best wishes
Lucas
RE: Message light or flash not working - techinburg - 01-29-2015 06:32 AM
I am having the same issue with a Yealink T-38G. It is attached to a Asterix PBX version 3.1.2. I have reset the phone to factory default - no change. I have loaded an older firmware - no change, and I have loaded the newest firmware, no change.
RE: Message light or flash not working - Yealink_Peter - 01-30-2015 07:13 PM
Hello techinburg,
I have sent message to your mailbox, please have a check.
Thanks.
Regards,
Peter