+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Configuration (/forumdisplay.php?fid=24)
+--- Thread: BLF(Broadworks) Icons Issue on T48G (/showthread.php?tid=2374)
Pages: 1 2
RE: BLF(Broadworks) Icons Issue on T48G - James_Yealink - 10-11-2014 10:53 AM
Thanks for new files.
I have tranasferred them to our engineer.
James
RE: BLF(Broadworks) Icons Issue on T48G - James_Yealink - 10-11-2014 04:00 PM
Hari,
It seems that you direclty put the autoprovision parameter into config.bin file then import the bin file?
It won't take effect. Only when phone do an autoprovision it will read the parameter.
You can try two method to configure the parameter:
1.Configure the parameter through autoprovision.
2.Change the parameter in .bin file then import it. Change the parameter SendResponseByRequest = 1 to SendResponseByRequest = 0 then import the .bin file.
Regards,
James
RE: BLF(Broadworks) Icons Issue on T48G - hari908 - 10-29-2014 02:31 PM
James,
Any further updates on this?
(10-06-2014 05:14 PM)hari908 Wrote: James,
I am facing the same problem even after setting sip.send_response_by_request= 0.
Attached are the pcap, config and logs as attachment Logs_6th_Oct.zip.
(09-30-2014 01:30 PM)Yealink_James Wrote: Sorry Hari,
I send a wrong parameter, the value should be 0.
sip.send_response_by_request= 0
Please try this autoprovision parameter.
Regards,
James
RE: BLF(Broadworks) Icons Issue on T48G - James_Yealink - 10-29-2014 04:15 PM
Hi Hari,
Please check my last reply.
When we check your config.bin file we found that the parameter is not configured properly.It seems that you direclty put the autoprovision parameter into config.bin file then import the bin file?
You can try two method to configure the parameter:
1.Configure the parameter through autoprovision.(recommended)
Autoprovision guide:
http://www.yealink.com/Upload/T2X/2014102/Yealink_SIP-T2_Series_T19P_T4_Series_IP_Phones_Auto_Provisioning_Guide_V72_1.pdf
2.Change the parameter in .bin file then import it. Change the parameter SendResponseByRequest = 1 to SendResponseByRequest = 0 then import the .bin file.
Regards,
James