+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Auto Provisioning (/forumdisplay.php?fid=14)
+--- Thread: Yealink RPS and Kerio Operator (/showthread.php?tid=2157)
Yealink RPS and Kerio Operator - marcowashere - 07-29-2014 10:11 PM
Hi all... Does anyone have any experience with Yealink's RPS service and Kerio Operator? Did you get it to work? What were the steps?
I've created a hardware provision for 2 Yealink T38G handsets in Operator, added extensions, set the extensions as being behind NAT, added our server to the RPS service, added the MAC address of the 2 handsets to the RPS service, and upgraded the handset firmware to 32.70.0.171.
However, the handsets just don't pickup the provisioning information.
When connected to the LAN, or if configured manually, the handsets work.
Any help or guidance would be greatly appreciated.
RE: Yealink RPS and Kerio Operator - RyanW - 07-29-2014 11:21 PM
Marco,
I've ran into this where the Firewall had Geo-IP and Botnet filters on. I disabled them and reset the phone and the device popped right up.
Ryan
RE: Yealink RPS and Kerio Operator - marcowashere - 07-29-2014 11:25 PM
Ah... I run the router / firewall, so not sure why this would be the case. I'm using Kerio Control router / firewall, so I should look there as my next step. Thanks for the advise.