Yealink Forums
How configure Remote control? - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Configuration (/forumdisplay.php?fid=24)
+--- Thread: How configure Remote control? (/showthread.php?tid=20066)



How configure Remote control? - gabrielangiuli - 08-10-2016 04:37 AM

Can you help me?

How can I configure remote control in yealink T19P E2 ?

I tried to set up with the manual of administrator, but could not.

Huh

Thanks for your help!!!


RE: How configure Remote control? - Lucia_Yealink - 09-27-2016 10:57 AM

(08-10-2016 04:37 AM)gabrielangiuli Wrote:  Can you help me?

How can I configure remote control in yealink T19P E2 ?

I tried to set up with the manual of administrator, but could not.

Huh

Thanks for your help!!!

Hi Sir,

Do you mean you want the server can control the phone? Then you should configure like the picture first.

For more information about the remote control, please refer to the guide from page 642 to 647:
http://Yealink_SIP-T2_Series_T19(P) E2_T4_Series_CP860_IP_Phones_Administrator_Guide_V80_130.pdf

Any question, please let me know.


RE: How configure Remote control? - joao.schlemm - 09-29-2016 01:01 AM

Hello,
I have a similiar issue!
When I try to connect to the phone (T19P) using a web browser, I receive the answer - "404 - Not Found" (must use https, because http does´t work)
The correct IP address was inserted in the "Action URI allow IP List"

Thanks in advance for your attention.


RE: How configure Remote control? - Lucia_Yealink - 10-10-2016 10:39 AM

(09-29-2016 01:01 AM)joao.schlemm Wrote:  Hello,
I have a similiar issue!
When I try to connect to the phone (T19P) using a web browser, I receive the answer - "404 - Not Found" (must use https, because http does´t work)
The correct IP address was inserted in the "Action URI allow IP List"

Thanks in advance for your attention.

Hi Sir,

When the IP phone receives a GET request from the trusted IP address for the first time, the LCD screen prompts the message “Allow Remote Control?”.
You should press Ok to allow remote contorl in the phone LCD.

If the problem still exist, please provide the level 6 syslog,config.bin and pace trace when you reproduce the issue with the detail peoblem to (Lucia@yealink.com).

About how to get the three files, please refer to the link below:
http://support.yealink.com/faq/faqInfo?id=313

Best Regards
Lucia Lu