Yealink Forums
T46 Vlan Enable - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Phone specific topic (/forumdisplay.php?fid=12)
+--- Thread: T46 Vlan Enable (/showthread.php?tid=1940)



T46 Vlan Enable - marksgt35 - 06-24-2014 04:56 AM

I have 3 T46 phones attached to a 3CX server. I have the Wan port set to Vlan enable with the vlan id at 172. If the phone reboots, the vlan enable setting changes to disable and the phone ends up on the data network. They are running firmware 28.71.0.224 which according to the support page is the latest 3CX supported firmware.


RE: T46 Vlan Enable - Yealink Support - 06-24-2014 03:47 PM

Hi marksgt35,

Please upgrade the firmware to latest version(28.72.0.25) and try again. The 28.72.0.25 version supports 3CX server.

You can download the firmware. >> 28.72.0.25 <<

About how to upgrade firmware, you can refer to more details in [FAQ]How to upgrade firmware?

thanks


RE: T46 Vlan Enable - marksgt35 - 06-24-2014 08:26 PM

I did at one point try that firmware. It is not compatible with the 3CX system however and the 3CX phone book did not work. The version that I am currently running is the latest that specifies it is 3CX compatible. Is 28.72.0.25 3CX compatible now as well?


RE: T46 Vlan Enable - Yealink Support - 06-24-2014 09:12 PM

Hi marksgt35,

Please follow follow steps:
1. You should check whether enable the Auto provision feature or not. Access to the webpage->Settings->Auto provision. Delete the content of Server URL field. Please refer to below picture.

[Image: attachment.php?aid=809]

2.If it also doesn't work, reset the phone and try again.

[Image: attachment.php?aid=810]