Auto Provision via YealinkIPPhoneExecute - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Auto Provisioning (/forumdisplay.php?fid=14) +--- Thread: Auto Provision via YealinkIPPhoneExecute (/showthread.php?tid=1867) |
Auto Provision via YealinkIPPhoneExecute - mores - 06-05-2014 08:28 PM Is there a way to Auto Provision the phone remotely using YealinkIPPhoneExecute from the XML Browser Developer's Guide ? RE: Auto Provision via YealinkIPPhoneExecute - Yealink Support - 06-06-2014 01:43 PM You can assign one DSSKEY to zml browser, then link to YealinkIPPhoneExecute via auto provisioning. RE: Auto Provision via YealinkIPPhoneExecute - mores - 06-06-2014 08:34 PM I think I might have found the answer. Page 37 of "Auto Provisioning Guide": The phone will perform the auto provisioning process when receiving a SIP NOTIFY message which contains the header “Event: check-sync”. If the header of the SIP NOTIFY message contains an additional string “reboot=true”, the phone will reboot immediately and then perform the auto provisioning process. This update mode requires server support. RE: Auto Provision via YealinkIPPhoneExecute - mores - 06-06-2014 09:35 PM And here is a good doc: http://www.yealink.com/Upload/document/HowtoremoterebootphonethroughSIPmessage/HowtoremoterebootphonethroughSIPmessageRev_610-20460023840.pdf RE: Auto Provision via YealinkIPPhoneExecute - juanma_megacall - 11-04-2015 12:40 AM Hi! Im dealing with this and works ok But the problem is im trying to change the provisioning server. I tried with Event: ua-profile;\r\n but i cant make it work |