Yealink Forums
How to Disable Provisioning - Printable Version

+- Yealink Forums (
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Auto Provisioning (/forumdisplay.php?fid=14)
+--- Thread: How to Disable Provisioning (/showthread.php?tid=1759)

How to Disable Provisioning - rwhirn - 05-16-2014 07:09 AM

At this time we are not doing auto provisioning, though we may do so in the future. However, new phones I just purchased with latest firmware seem to want to auto-provision when they start up. T22 phone startup says "Initializing" for 50 seconds and then comes a popup "Sending Provision Requests" which will stay there for 3 minutes (unless you hit "Cancel"), whereupon it then says "Initializing" again for another 30 seconds before finally starting up.

I have tried setting under "Auto-Provision":
Zero Active Disabled
Power On Off
Repeatedly Off

Is there any way to disable this?

RE: How to Disable Provisioning - Yealink Support - 05-17-2014 11:15 AM

What is your firmware of T22 now? Is it a RPS firmware?

RE: How to Disable Provisioning - rwhirn - 05-29-2014 03:09 AM

I recently upgraded to the latest version to fix the 10mbps PC-port connection problem. These are brand new phones, I believe they had 7.71 when I took them out of the box.
Firmware Version
Hardware Version

RE: How to Disable Provisioning - Yealink Support - 06-03-2014 03:01 PM

Hi rwhirn,

Do your phones provision again?