T42G Flashes Yealink Logo - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: T4x Series (/forumdisplay.php?fid=31) +--- Thread: T42G Flashes Yealink Logo (/showthread.php?tid=1601) |
T42G Flashes Yealink Logo - joebocop - 04-17-2014 11:16 AM I have a T42G that, even after provisioning, factory reset, firmware upgrade, etc... displays the "Yealink" logo for approximately 3 seconds every 10 seconds. How do I disable this? It is very annoying. RE: T42G Flashes Yealink Logo - Yealink Support - 04-17-2014 02:07 PM Please go to the webpage->Features->General Information, choose Use Logo as "off". RE: T42G Flashes Yealink Logo - joebocop - 04-18-2014 12:43 AM Thank you. Does that disable any logo from appearing, including any custom logos (on the T46g, say)? Is there a way to apply this to one hundred phones without having to touch the web GUI of each? RE: T42G Flashes Yealink Logo - Yealink Support - 04-18-2014 11:34 AM 1. T46G supports wallpaper but not logo. 2. Yes. This settings disable all logo from appearing. 2. You can configure this in auto provisioning files and make a mass deply. Take T42G for example: ------------------------------------------------ #!version:1.0.0.1 ###Except T46G Model ##It configures the logo mode of the LCD screen (except for SIP-T20P IP phones). ##For SIP-T19P/T21P/T22P/T26P/T41P/T42G IP phones: ##0-Disabled 1-System logo 2-Custom logo ##The default value is 0. ##For SIP-T28P IP phones: ##1-System logo 2-Custom logo ##The default value is 1. ##It enables or disables a text logo (for SIP-T20P IP phones). ##0-Disabled 1-Enabled ##The default value is 0. phone_setting.lcd_logo.mode = 0 ------------------------------------------------ |