T22/T38G Ring timeout - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: Phone specific topic (/forumdisplay.php?fid=12) +--- Thread: T22/T38G Ring timeout (/showthread.php?tid=1511) |
T22/T38G Ring timeout - plugworld - 04-01-2014 10:59 PM Hi, I have two types of yealink phones in our organisation T22 and T38G. For both, even if in the PBX I set a ring timeout of 5 minutes, the phone send a busy after only 2 minutes. Where can I find the setting to let the phone ring forever and let the SIP PBX decide when to cancel a ringing call. Thanks RE: T22/T38G Ring timeout - Yealink Support - 04-02-2014 10:42 PM Do you eanble " No Answer Forward" to 120 senonds? RE: T22/T38G Ring timeout - Bryan Nelson - 04-23-2014 03:06 AM You may also want to check if session timers are enabled on the phone or on the PBX side. Session timers will often kill a call at 2 minutes when there is no active RTP audio stream. If you can capture the SIP dialog, you should be able to see which side issues the BYE signal -- and that is the side running a session timer. Hope that helps! |