[solved] W52P firmware update to 25.50.0.20 failed - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: Dect Phone Series (/forumdisplay.php?fid=6) +--- Forum: W52P (Wireless) (/forumdisplay.php?fid=23) +--- Thread: [solved] W52P firmware update to 25.50.0.20 failed (/showthread.php?tid=1487) |
[solved] W52P firmware update to 25.50.0.20 failed - mkeuter - 03-28-2014 12:07 AM The firmware update from 25.40.0.15 to 25.50.0.20 failed for my W52P. After an hour were the upper and lower LEDs were on and the middle LED was blinking constantly, I rebooted the base station. Now only the lower LED is on and middle LED is blinking, but I cannot access the base via Webpage. On my router I can see that there is a DHCP request from the base, and the the router tries to assign an IP-address, but that's all. Is there a way to recover the base station via TFTP or such? Any help is appreciated. Michael Update: these are the messages from my DHCP server (dnsmasq): Code: Mar 27 17:10:42 jrouter daemon.info dnsmasq-dhcp[2549]: DHCPDISCOVER(eth1) 00:15:65:48:df:98 RE: W52P firmware update to 25.50.0.20 failed - mkeuter - 03-28-2014 02:22 AM Update: The 25.50.0.20 update has broken the DHCP function. I could use the handset to configure a static IP, then I could use WebGUI, and downgraded to the last working 25.40.0.15 version. But the DHCP function is still broken, even in the older firmware version. RE: W52P firmware update to 25.50.0.20 failed - Yealink Support - 03-28-2014 07:17 PM Can you check with your network technical engineer? RE: [solved] W52P firmware update to 25.50.0.20 failed - mkeuter - 03-28-2014 08:22 PM Forget my post. I had some strange DHCP issues in my network. The firmware works fine. |