+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: T4x Series (/forumdisplay.php?fid=31)
+--- Thread: T46G display blinks after Backlight Time(seconds) timeout (/showthread.php?tid=14091)
T46G display blinks after Backlight Time(seconds) timeout - wills - 04-20-2016 09:26 PM
Hi All,
I have a T46G on the latest firmware 28.80.0.95.
If I set the Backlight Inactive Level to low or off.
After the timeout occurs when the phone is not in use, the display will either randomly blink between the low and a high backlight or when the Backlight inactive level is set to off, it blinks (the display backlight comes on for a second).
I've tried resetting the phone to factory defaults.
Any Ideas?
RE: T46G display blinks after Backlight Time(seconds) timeout - Karl_Yealink - 04-27-2016 07:14 PM
I test here, everything work normally.
If you reset the phone, can the phone work normally again?
Is that the MWI cause the blacklight change the status? Please check.