Yealink Forums
DTMF Relapce Tran not working correctly - Printable Version

+- Yealink Forums (http://forum.yealink.com/forum)
+-- Forum: IP Phone Series (/forumdisplay.php?fid=4)
+--- Forum: Phone specific topic (/forumdisplay.php?fid=12)
+--- Thread: DTMF Relapce Tran not working correctly (/showthread.php?tid=13794)



DTMF Relapce Tran not working correctly - 1stvan - 04-08-2016 10:25 PM

Dear Support,

I have a problem:
If enable "DTMF Replace Tran" and DSS (MEMO) key in BLF mode, phone send only "Trans Send DTMF" code.

Settings:

DTMF Replace Tran: enabled
Tran Send DTMF: ##

Memory or Line key 1:
Type: BLF
Value: 302
Line: Line 1
Extension:

Memory or Line key 2:
Type: BLF
Value: 303
Line: Line 1
Extension:

If I press any Memory button, phone send ## (Tran Send DTMF). Missing the extension number.
I tested several phone type (T23, T26, T27, T28) All operate same way.
(The BLF workink correctly)

What could be the problem?

Thank You
Istvan


RE: DTMF Relapce Tran not working correctly - Karl_Yealink - 04-13-2016 06:07 AM

Description:
Enables or disables the IP phone to send DTMF sequences for transfer function when
pressing the Tran/Transfer soft key or TRAN/TRANSFER key.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the IP phone will perform the transfer as normal when
pressing the Tran/Transfer soft key or TRAN/TRANSFER key during a call.
If it is set to 1 (Enabled), the IP phone will transmit the designated DTMF digits to the
server for performing call transfer when pressing the Tran/Transfer soft key or
TRAN/TRANSFER key during a call.

From the descrpition above, it's normally, if you enable this function.
The phone only will send the DTMF code.


RE: DTMF Relapce Tran not working correctly - Robort2 - 06-02-2016 02:07 PM

Hi 1stvan Im Robot i'm currently working in http://www.click2dissertation.co.uk , I think this form is not so helpful for our questions.

Wait Until Support see this message